Fence Panel & Insert Privacy Screens Manual Assembly
Privacy Screen Insert Installation
-
1ST STEP: Pre-drill the Screw Holes
Using the drill, pre-drill holes at each of the marked locations. The drill bit size should be slightly smaller than the diameter of the screws.
-
2ND STEP: Attach the metal insert privacy screen to the wooden frame.
Place the metal insert privacy screen against the wooden frame, aligning the screw holes with the pre-drilled holes. Use the screwdriver to attach the metal insert privacy screen to the wooden frame using the screws provided.
Privacy Screen Fence Panel Installation
-
1ST STEP: Align and Mark Screw Holes
To ensure a seamless installation, begin by carefully aligning the PRIVACY SCREEN FENCE PANEL with the wooden frame. Make sure each screw hole on the panel perfectly matches its intended location on the frame. Once everything is lined up precisely, use a pencil or marker to transfer the exact location of these screw holes onto the wooden frame. This will create accurate guides for drilling the holes in the next step.
-
2ND STEP: Secure the Privacy Screen Panel
After aligning the panel and marking the screw holes on the frame, take the 16 provided screws and insert them through the corresponding markings. Using a screwdriver, firmly tighten each screw to secure the PRIVACY SCREEN FENCE PANEL to the wooden frame. Be sure the screws are snug but not overtightened to avoid damaging the panel or frame.
